Dt Sheet. Precise magnetic switching points and high temperature stability are achieved through the unique design of the internal circuit. An onboard clock scheme is used to reduce the average operating current of the IC. During the operate phase the IC compares the actual magnetic field detected with the internally compensated switching points. The output Q is switched at the end of each operating phase. The IC switching behaviour is Omnipolar, i.
|Published (Last):||27 June 2013|
|PDF File Size:||19.92 Mb|
|ePub File Size:||6.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
Micro power design? High sensitivity and high stability of the magnetic switching points? High resistance to mechanical stress? Digital output signal? Precise magnetic switching points and high temperature stability are achieved through the unique design of the internal circuit. An onboard clock scheme is used to reduce the average operating current of the IC.
During the operate phase the IC compares the actual magnetic field detected with the internally compensated switching points. The output Q is switched at the end of each operating phase. During the Stand-by phase the output stage is latched and the current consumption of the device reduced to some?
The IC switching behaviour is Omnipolar, i. The bias generator provides currents for the Hall probe and the active circuits.
Compensation circuits stabilize the temperature behavior and reduce technology variations. The Active Error Compensation rejects offsets in signal stages and the influence of mechanical stress to the Hall probe caused by molding and soldering processes and other thermal stresses in the package. This chopper technique together with the threshold generator and the comparator ensures high accurate magnetic switching points.
Very low power consumption is achieved with a timing scheme controlled by an oscillator and a sequencer. This circuitry activates the sensor for 50? In the standby phase the average current is reduced to typical 4? Because of the long standby time compared to the operating time the overall averaged current is only slightly higher than the standby current. Data Sheet 3 V 2. Supply Voltage VS — 0.
Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Supply voltage VS 2. A mA mA? VS must be applied in this time typ. Data Sheet 5 V 2. BOPS 2 3. Typical characteristics specify mean values expected over the production spread. Your feedback will help us to continuously improve the quality of this document. Please send your proposal including a reference to this document to: feedback.
Attention please! The information herein is given to describe certain components and shall not be considered as warranted characteristics. Terms of delivery and rights to technical change reserved. We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding circuits, descriptions and charts stated herein. Information For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon Technologies Office in Germany or our Infineon Technologies Representatives worldwide see address list.
Warnings Due to technical requirements components may contain dangerous substances. For information on the types in question please contact your nearest Infineon Technologies Office. Infineon Technologies Components may only be used in life-support devices or systems with the express written approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device or system.
If they fail, it is reasonable to assume that the health of the user or other persons may be endangered. Data Sheet 12 V 2.
Something went wrong...
TLE4913 INFINEON Hall Effect Sensor 2mA Omnipolar 2.5V/3.3V/5V 3-Pin SC-59 Sensor ICs 10
TLE4913 PDF Datasheet浏览和下载
TLE4913 Switch. Datasheet pdf. Equivalent